Class A approved marker film, left side - standard TPESC-A-19112 - Roll: 0.65 m x 0.14 m

For construction and intervention vehicles, it is now essential to dress them with reflective adhesive strips approved by French law! For that, Variance Auto accompanies you with a choice of 2 types of stickers of marking, here, you will find the film of marking approved class A which is addressed to the vehicles of building sites and interventions which circulate at average speed (not more than 90km/h) and which wishes a visibility being able to go until 100 meters.

This right hand side marker sticker is available in rolls that can be cut to a length of 9 linear metres and a width of 14 cm or 28 cm. Do not hesitate to contact our advisers for any question on this subject!

To find out more about class B marking tape, please visit the product sheet for : Class A approved marking film.

As a reminder, according to French law, you must respect certain installation rules concerning the application of these adhesive reflective strips:

• Front: 2 adhesive reflective strips are required, with a minimum surface area of 0.16m², hatching outwards on either side of the centre of the bonnet.
• Rear: 2 vertical stripes + 2 horizontal stripes of minimum 0.32m².
• Sides: 1 strip on each side of minimum 0.16m².

Please note that the crosshatching of the reflective stripes on the left side should always be oriented in this way: the diagonals run downwards from the inside to the outside left.